After a mesh box is set up and at the Devices page, selecting

a mesh box and then “configure”, was able to modify the device ports but when clicking on “Next”, the screen shifts and is too high.  The back arrow and “Add” are in the top extreme corners of the screen so that the i-phones clock and battery status overlay the back arrow and “Add”.  See screen shot below. The screen is locked and while I can select a sensor and “reset” the sensor, I wasn’t able to move forward or go backwards and needed to close and restart the app.  The changes made were not stored.  This occurred with both an 850.00.042 and an 850.00.912. Also note in the screen shot the yellow back arrow and add comments are extremely difficult to read in daylight mode.

I linked already existing ticket. We are working on it.